Mastering Bluetooth: A Step-by-Step Guide

WattCycle Bluetooth guide

WattCycle Bluetooth Guide

WattCycle’s official new Bluetooth Battery App is now available for both iOS and Android. iOS users can download it from the App Store by searching “WATTCYCLE” and Android users can find it on Google Play. The original version will remain active, so feel free to choose the one that suits you best. The latest version offers enhanced features—including New Parallel Mode, Fahrenheit conversion and parameter adjustments—to meet all your needs. Please update at your earliest convenience. For any inquiries, contact service@wattcycle.com.

For original version (BMS Meta) Password is 888888

New WattCycle Bluetooth APP (WattCycle®) no need Password

Note:Alternatively, you can leave a comment at the bottom with your email address. We will reply to you via email, as we are unable to respond to your comment directly.

Codes Meaning of Warning

This is the code meaning of the "Warnings page" in the Bluetooth APP.

Codes Name Codes Meanings
CHG OT Alarm Charging over-temperature alarm
DSG OT Alarm Discharging over-temperature alarm
CHG UT Alarm Charging under-temperature alarm
DSG UT Alarm Discharging under-temperature alarm
ENV OT Alarm Environmental over-temperature alarm
ENV UT Alarm Environmental under-temperature alarm
MOS OT Alarm Mos over-temperature alarm exists
Cell OVP(V) Single cell over-voltage protection
Cell UVP Alarm(V) Single cell under-voltage protection
Pack OVP(V) Pack over-voltage protection
Pack UVP(V) Pack under-voltage protection
CHG OCP(A) Over-current during charging
DSG OCP(A) Over-current during discharging
Hardware protect Hardware protection
High CHG volt High charging voltage
CHG OTP(°C) Charging over-temperature protection
DSG OTP(°C) Discharging over-temperature protection
CHG UTP(°C Charging under-temperature protection
DSG UTP(°C) Discharging under-temperature protection
MOS OTP(°C) Mos over-temperature protection
ENV OTP(°C) Environmental over-temperature protection during charging
ENV UTP(°C) Environmental under-temperature protection
CHG ON Charging
DSG ON Discharging
CHG MOS Fault Charging MOS failure
DSG MOS Fault Discharging MOS failure
Temp fault Temperature failure
Cells fault Battery cell failure
Cell OV Alarm Single cell over-voltage alarm
Cell UV Alarm Single cell under-voltage warning
Pack OV Alarm Pack over-voltage alarm
Pack UV Alarm Pack under-voltage warning
CHG OC Alarm Charging over-current alarm
DSG OC Alarm Discharging over-current alarm
Hardware protect Alarm Hardware protection warning

Comments

  • KRYVOPYSHA ANDRII 2026-09-07 12:37
    Где в приложении данные по: 1 остаточная ёмкость, 2 количество циклов?
  • Bryan Tanner 2026-08-31 21:05
    I am using the Ecoflow and watt cycle 5120 battery combo, the battery wont begin discharge until the ecoflow delta 3 is below 60% even when the battery is full, is there a way to begin discharge along with ecoflow delta 3? I start with them both at 90% full and the ecoflow discharges but the watt cycle doesn’t until the ecoflow it almost half drained, I loose power when the battery still has life, because they don’t discharge together at the same rate
  • Guy Marquis 2026-08-30 08:36
    Loose definitively bluetooth conection with a 628 ah batt with bms 300 Amps!
  • Guy Marquis 2026-08-30 08:36
    Loose definitively bluetooth conection with a 628 ah batt with bms 300 Amps!
  • Leonard Teasca 2026-08-25 15:28
    Chg mosfet charging failure, the app shows an error but my battery charger is charging it , it shows 75 % charge state, tried reset and factory reset , chg mosfer still present
  • Zdzisław Bela 2026-08-19 01:28
    App shows wrong parameters. Battery turns off in random moments. Please support
  • David Seidel 2026-08-07 12:25
    Bluetooth won’t conect
  • Oliver 2026-07-30 06:57
    I had my 314ah arctic version all set up with the votronic system. Then I started the app an the numbers of charging state were a bit off. I pushed the “discharge” (entladen) button in the app and EVERYTHING shut down!!. Is this the on/off button off the battery??? It’s not even explained! after i pushed this button again it turned back on BUT NOW IT SUDDENLY IS ALMOST EMPTY! WOULD you PLEASE help me? I’m sitting in my camper, this is my HOME and this app probably broke my new battery!
  • Jamie Morgan 2026-07-27 07:04
    Paid a lot of money for a battery that wants to control to much has me shut of can’t charge
  • Dan 2026-07-27 04:33
    One mini 314 smart in a bank of 4 in parallel went to 0% SOC even though low voltage disconnect was set at 11.0v. Why. And it won’t take a charge. I tried factory reset, off parallel mode. Nothing. What do I do to get it to take a charge?

Leave a Comment

Recent Posts