large bitesWhat does this have to do with batteries?

Are you sure they aren't in parallel?  (200Ah at 12V)It sounds like you have a bad jumper between two parallel batteries.  Only one would be discharged.If you are indeed running a 24V tro...

How about updating the app so that it will work for a stack of the rack batteries when they are networked for commo with an inverter/charger?Only one battery can be connected to the phone app, and ...

@William Setzer Most battery chargers are too "smart" for their own good.  They won't put out anything unless the battery is above a certain voltage.  What I do - and it has not yet faile...

@Joey Also, the Factory Data Reset button is again returning an "Operation Failure" message.

@Joey . The new app has my batteries bahaving very strangely. Two (24v 314ah UltraSmart) batteries in parallel. As we see in the picture, with a 33amp load on the system, Bat 1. is putting out 36 a...

@Tobias Yeah, it's very beta atm. They'll sort out all these little things (which is why they're asking us about them).

@peterp After binding (with the new Android app) I can still can disable discharge (switch off load) with the IPhone app. Toogling charge doesn' seem to work, it says "saved" but reverts back. 

@Joey OK, I'm having problems with this version of the app disconnecting from the batteries. It's done it a few times now in the first 24 hours. Then is difficult to reconnect (or even to see the b...

Do I just hook to 20 amp or greater lithium battery charger?  What about a ground? Thanks Darrell

thanks

@Tobias, you (I) cannot change any settings without being bound to the battery. I can only see them otherwise.

Yes, a bit of a pita, but at least it works. (Cannot change any settings without binding). Still having issues with one battery at 40% and the other at 98%. So it definitely needs more work.  

I had a terrible time scanning the barcode. It just wouldn't work. The camera looked like it had poor contrast and wasn't focused well. I had to enter the serial number manually. What a pain that w...

@Joey what is the expected date for the update app with the password? 

What do people use when storage of Lithium battery in cold temps?  

When can we expect the iOS app with the security implementation? By the way, even after binding the battery, I can still access it from another app!!!

Put them in parallel mode via the app 

I have been reading abou the uneven discharge problems for quite a while.  I finally have my two 280 AH batteries setup in parallel mode and parallel is enanbled in the app. Two start with I ...