I fought with my batteries all day and finally got them to charge and discharge. The 314 would not turn on if the 100's were on and vice versa. This was during initial set up with a new Victron Multiplus. All batteries were at 100% when I started. I finally got the Victron configured using the big battery and then started to work with the settings for the batteries. After frustration for hours, I set all the batteries to the exact same settings and then went into parallel setting and chose the compatability setting......it worked! Now I need some one to confirm the method of pulling power out of each battery. I put on some heavy loads and checked each battery for amp draw. I noticed that the 100's were pretty close together and the 314 was about 3 times more then them. Both 100's were at 30 to 33 and the 314 was at 94.....Is this correct and will it take them down evenly?
Kevin
