Thanks, @Shawn Wright yes, the parallel mode is enabled, but the batteries behave this way without it enabled anyway. They are improving as I cycle them up and down but I would like to get a better...
Thanks, @Shawn Wright yes, the parallel mode is enabled, but the batteries behave this way without it enabled anyway. They are improving as I cycle them up and down but I would like to get a better...
@Louis Ash . Thank you, Louis. More food for thought.
@clifton chowning , these guys aren't trying to dupe you. They just have appalling customers service response. They will replace or refund your purchase but it will take some time.
I have a question about how the BMS knows (or works out) how much charge is in the battery, and how much it should be able to hold. My shunt/monitor does not track very closely to what the ...
@Tom Westhoff No, the vid won't play for me either. (It just showed how everything went off if you turned off discharge). They are both behaving strangely still, but not too bad. I think they are j...
@Tom Westhoff Sorry, yes, the 25_11.11.beta4. The beta does now work with 24v batteries (parallel works anyway) but this behaviour has been happening for a while now. I'll post a vid showing what h...
Still having regular disconnection of batteries from bt too. at least daily.
@Tom Westhoff I'll have to look into that tomorrow, Tom, but yesterday I managed to get things running better. I took both batteries to under 20% then charged them up with mains power. After gettin...
@Joey Also, the Factory Data Reset button is again returning an "Operation Failure" message.
@Joey . The new app has my batteries bahaving very strangely. Two (24v 314ah UltraSmart) batteries in parallel. As we see in the picture, with a 33amp load on the system, Bat 1. is putting out 36 a...
@Tobias Yeah, it's very beta atm. They'll sort out all these little things (which is why they're asking us about them).
@Joey OK, I'm having problems with this version of the app disconnecting from the batteries. It's done it a few times now in the first 24 hours. Then is difficult to reconnect (or even to see the b...
@Tobias, you (I) cannot change any settings without being bound to the battery. I can only see them otherwise.
Yes, a bit of a pita, but at least it works. (Cannot change any settings without binding). Still having issues with one battery at 40% and the other at 98%. So it definitely needs more work.
Another thing in the app which needs to be fixed is the charge/discharge algorithm. It appears to be out by about a factor of ten. My batteries will usually discharge about 10% per day (unless I am...
Four days into owning two WattCycle 25v 314ah batteries, the app has stopped working. It connects, and the batteries are working (powering the inverter) but the app -after connecting to the battery...
@Rascally Only if you're looking at 12v. Fixes are not implemented in higher voltages ...Clearly, they are still shaking out the bugs. I would not have just laid out $4,000 if I had known this.
Is there a way to turn charging off until I want it turned on again? Currently, when I turn charging off, the batteries just turn it on again as soon as the sun comes up. I want it off for two or t...
I'm told by support that the Parallel Mode is not supported by 24v batteries, only 12v. I asked if it was being implemented for 24v but have recieved no answer. So I am formally requesting it.