@peterp That is not working correctly. With 12V in parallel it is much better behaved. This version does not work as well as the last stable (in store) version. I hope they fix this soon. I couldn...

@Tom Westhoff Sorry, yes, the 25_11.11.beta4. The beta does now work with 24v batteries (parallel works anyway) but this behaviour has been happening for a while now. I'll post a vid showing what h...

I am brand new to this forum.  Where can I tell the app that my batteries are in parallet or series mode?  

Still having regular disconnection of batteries from bt too. at least daily.

@Tom Westhoff I'll have to look into that tomorrow, Tom, but yesterday I managed to get things running better. I took both batteries to under 20% then charged them up with mains power. After gettin...

@peterp That's weird.  Is this the 2025.11.11 B4 version? I know they haven't been keeping up with the 24V batteries, concentrating on the 12V. Shutting Off Charge does not shut off Discharge...

large bitesWhat does this have to do with batteries?

Are you sure they aren't in parallel?  (200Ah at 12V)It sounds like you have a bad jumper between two parallel batteries.  Only one would be discharged.If you are indeed running a 24V tro...

How about updating the app so that it will work for a stack of the rack batteries when they are networked for commo with an inverter/charger?Only one battery can be connected to the phone app, and ...

@William Setzer Most battery chargers are too "smart" for their own good.  They won't put out anything unless the battery is above a certain voltage.  What I do - and it has not yet faile...

@Joey Also, the Factory Data Reset button is again returning an "Operation Failure" message.

@Joey . The new app has my batteries bahaving very strangely. Two (24v 314ah UltraSmart) batteries in parallel. As we see in the picture, with a 33amp load on the system, Bat 1. is putting out 36 a...

@Tobias Yeah, it's very beta atm. They'll sort out all these little things (which is why they're asking us about them).

@peterp After binding (with the new Android app) I can still can disable discharge (switch off load) with the IPhone app. Toogling charge doesn' seem to work, it says "saved" but reverts back. 

@Joey OK, I'm having problems with this version of the app disconnecting from the batteries. It's done it a few times now in the first 24 hours. Then is difficult to reconnect (or even to see the b...

Do I just hook to 20 amp or greater lithium battery charger?  What about a ground? Thanks Darrell

thanks

@Tobias, you (I) cannot change any settings without being bound to the battery. I can only see them otherwise.

Yes, a bit of a pita, but at least it works. (Cannot change any settings without binding). Still having issues with one battery at 40% and the other at 98%. So it definitely needs more work.